S Shape PC Hollow Sheet Production Line

  • This line is used to produce S shape PC hollow sheet.
  • 1. 100% recycled material can be added.
    2. High speed screw, low energy consumption with high rotation speed to match gear pump and stable pressure, output capacity is 25% higher than other brand extrusion lines because of special design of forming plates.
    3. Specially designed cooling system for all sections of forming plates, and a uniquely designed vacuum system for each section of forming plate.
    4. Specially designed temperature control oven with cross heat shrinks forming.
    5. Dies are designed for saving UV, production cost and we hold the full set of production techniques.
    6. The air capacity of hollow sheet and low pressure could be adjusted and controlled
    7. Unique design of T-Die for hollow sheet. The thickness of hollow sheet could be produced from 4mm to 36mm and the sheet composed by walls from twin-wall, triple-wall to 4-wall even multi walls.
    8. Anti-UV co-extrusion layer could be one sided or two-sided, outer surface could be sandy or glossy according to the configuration of the line.
    9. The vacuum calibrator features wear-resistance, dirty free and the lifting, falling and leveling for the forming plates is much easier to control.


    • Main screw diameter
    • Width of sheet
    • Thickness of sheet
    • Output

Related Products

Send message to us

Verification code